Canon MB2100 SERIES Online Manual page 1039

If you specify IPv6 address:
1. Select IPv6 and press OK button.
2. Select Yes on displayed screen and press OK button.
3. Select Enable/disable IPv6 and press OK button.
4. Select Enable and press OK button.
The IPv6 address has been specified.
Important
• If firewall is enabled on the computer, printers on a different subnet may not be detected. Disable
firewall.
If firewall interferes with printer search:
• If message appears:
If a message appears warning that Canon software is attempting to access the network, set the
security software to allow access.
After allowing the software to access, specify the IP address or host name and search for printers
again.
If the printer is found, follow the instructions on the screen to continue to set up the network
communication.
• If no message appears:
Cancel searching printers, and then set the security software to allow Canon software below to
access the network.
Setup.exe or Setup64.exe in the win > Driver > DrvSetup folder on the Setup CD-ROM
After setting the security software, specify the IP address or host name and search for printers again.
Note
• For more on firewall settings of your operating system or security software, see instruction manual or
contact its manufacturer.
1039