Table of Contents
Advertisement
ITC Series
6.5. Safe Mode
What is Safe Mode?
There may be certain occasions that your camera repeatedly fails to boot. Then, your camera
may enter safe mode to be recovered from the occasions.
What may have caused Safe Mode?
Here below are the main typical causes.
* The power supply is continually unplugged certain times in the middle of system booting.
* The firmware files required for system booting are damaged.
* There are conflicts in the system settings.
How to recover your system from Safe Mode
The messages above will appear on the webpage when your device has been rebooted in safe
mode. Then, you should follow the instructions on the webpage according to each step.
i
There is another method to update firmware, which is using IPAdminTool.
Please refer to 'IPAdminTool User's Manual.pdf' for the detailed procedure.
Note
If your device is still in safe mode after trying to update firmware, please contact
your local agency to get further assistance.
21
CBC AMERICAS CORP. - EAST COAST +1 (919) 230-8700 | WEST COAST +1 (310) 222-8600 | MEXICO +52 (55) 5280-4660
ITC6500 Series Installation Guide
Browse
ganzsecurity.com. 01/17
Advertisement
Table of Contents
