Closing The; Installing The Sunshield; Adjusting Image Focus - Ganz ZNT1-H Series Installation Manual

ITC Series ITC6500 Series Installation Guide
4.4. Closing the Back Cover
1) Insert the provided silica gel packet inside the back panel.
2) Close the back panel of the camera by twisting the back cover clockwise on the camera's back
panel.
3) Insert the two tamper resistant screws into the holes on the back cover, and tighten them
with a Phillips #2 screwdriver to fix the back cover to the camera unit.

4.5. Installing the Sunshield

1) Insert the two provided stem bumpers to the holes at the bottom of the sunshield.
2) Place the sunshield on top of the camera body, and snap the sunshield to the base mount.

4.6. Adjusting Image Focus

The camera is pre-focused at factory to suit each FOV. However, in case you need to adjust the
focus for optimal image quality at your installation site, you can manually set the focus by
rotating the lens with hand.
The lens may be a little difficult to turn due to the O-ring behind the lens. Try to turn the lens
counter-clockwise first to move the lens away from the base. Once the lens moves, start
turning it in either direction for focusing by grabbing the barrel of the lens with one hand and
grabbing the base unit with the other hand.
11 CBC AMERICAS CORP. - EAST COAST +1 (919) 230-8700 | WEST COAST +1 (310) 222-8600 | MEXICO +52 (55) 5280-4660
ganzsecurity.com. 01/17