Table of Contents
Advertisement
ITC Series
③ RS-485 Connection
The RS-485 serial port consists of TRX+(RX+) and TRX-(RX-) like the following image.
④ Power Connection
The camera can be powered by either 12VDC, 24VAC, or PoE. If the camera is powered via
PoE, you do not need to connect the power adaptor. For more information about PoE, refer
to "Appendix (C). Power over Ethernet" for more information.
To operate your camera by using 12VDC, make sure the polarity is correct before
connecting the power cable. Incorrect connection may cause damage to the device.
⑤ RJ45 Connection
This is a RJ45 LAN connector for 10/100 Base-T Ethernet. Use the Ethernet cable (RJ45) to
connect the device to a hub or a router in the network. Refer to "Appendix (C). Power over
Ethernet" for more information.
⑥ Analogue Video Output Connection
Use a 75-ohm video coaxial cable to connect to a monitor's analog video input.
The factory default for analogue video output is NTSC. Press once to set the video to PAL,
and press again to set the video to NTSC.
15
CBC AMERICAS CORP. - EAST COAST +1 (919) 230-8700 | WEST COAST +1 (310) 222-8600 | MEXICO +52 (55) 5280-4660
Black
Red
ITC6500 Series Installation Guide
485 Device
ganzsecurity.com. 01/17
Advertisement
Table of Contents
