Descaling Procedure - Philips EP4051 User Manual

English
20

Descaling procedure

START
CALC
CLEAN
REMOVE
FILTER
When the display shows START CALC CLEAN, you need to descale the
machine. If you do not descale the machine when this message appears on
the display, the machine will eventually stop working properly. In that case,
repairs are not covered by the warranty.
Only use Philips/Saeco descaling solution to descale the machine. The use
of other products may damage the machine and leave residues in the water.
You can buy descaling solution in the online shop at
www.philips.com/coffee-care.
The descaling procedure lasts 30 minutes and consists of a descaling cycle
and a rinsing cycle. You can pause the descaling or rinsing cycle by pressing
the escape button. To continue the descaling or rinsing cycle, press the OK
button.
Note: Do not remove the brew group during the descaling procedure.
Warning: Do not drink the descaling solution or the water
dispensed during the descaling procedure.
1 Remove the drip tray and the coffee grounds container, empty and clean
them and put them back into place.
2 Place a large container (1.5 l) under the coffee dispensing spout.
3 When the display shows START CALC CLEAN, press the OK button to
start the descaling procedure. Remove the hot water dispensing spout if
present.
-
The display reminds you that you have to insert the carafe. Fill the
milk carafe with water up to the MIN level indication. Insert the milk
carafe into the machine and open the milk froth dispensing spout.
-
The display reminds you that you have to open the milk dispensing
spout.
-
The display reminds you that you have to remove the AquaClean
filter.
Note: You can press the escape button if you want to start the descaling
procedure later. To perform the descaling procedure later, press the
MENU button, select MENU and scroll to select DESCALING. Press OK to
confirm.