DataApex Shimadzu GC2010 APC/AFC User Manual page 9

Shimadzu GC-201x
In the System Configuration
l
Available Control Modules
Select the Shimadzu GC- 201x in the GC section and press the Add
l
button.
The Shimadzu GC-201x Setup
l
Fill in the Port, Baud Rate and Name according to the settings and the
l
connection of the GC (for more details see the chapter Shimadzu GC-
201x Setup on pg 24)..
Press the Autodetect button to read all settings from the instrument and
l
apply them in the
Note: It is strongly recommended not to change the settings gained through the
Autodetect function. When opening the
settings are checked against the settings of the GC and in case they are
not the same the warning message is issued and no control is possible.
Note: Only GC2010 and GC2014 models are autodetected properly. When
using GC2014C or GC2014 APC/AFC , the exact type used needs to be
selected after autodetection.
Switch to the
l
Setup dialog section later in the manual ), select the correct number of
signals you want to acquire, name them and possibly check the This
Device Starts the Run in Clarity / Clarity Starts This Device radiobutton.
The Clarity Starts This Device option should be checked only when the
GC will not start the acquisition (that means it will not be triggered by the
GC Start button, external start contact or autosampler). Press the OK
button.
dialog press the Add button
dialog.
dialog will appear.
Fig 4: Shimadzu GC-201x Setup
Shimadzu GC-201x Setup
Signals tab (for more details see the
dialog.
Instrument
- 5 -
3 Installation Procedure
①
to invoke the
window, those
Shimadzu GC- 201x