Shimadzu Gc-201X Setup - DataApex Shimadzu GC2010 APC/AFC User Manual

4 Using the control module

4.5 Shimadzu GC-201x Setup

Dialog tabs:
Shimadzu GC- 201x Setup
Configuration
configuration of the chromatograph. All fields (with the exception of Name
field and the
the Autodetect button.
Caution: It is highly recommended not to change any data read from the
chromatograph by the Autodetect function, because these settings are
checked against those in the GC when opening the
they don't match, the control is not possible. The only parts of the dialog
that can be modified without risk is the Name parameter on the
Connection
Connection tab
Main page of the
Port
Selects the COM port to which the Shimadzu GC-201x chromatograph is
connected.
Baud Rate
Sets the baud rate of the communication. For a chromatograph directly
connected to the PC via short cable it is recommended to set the Baud
Rate to 115200, for the chromatograph connected by long serial cable or
through LAN it will be necessary to set the Baud Rate lower. Default value
is 115200.
Caution: The baud rate set in this dialog must correspond to the baud rate value set
in the chromatograph.
Connection - Piping
dialog) allows to view and manually set the hardware
Signals tab) can be read from the chromatograph by using
tab and any data on the
Fig 20: Shimadzu GC-201x Setup - Connection
Shimadzu GC-201x Setup
- Signals - Heater Ports
dialog (accessible through the
Signals tab.
dialog.
- 24 -
Clarity Controls
- Line Config
System
Instrument window. If