DataApex Shimadzu GC2010 APC/AFC User Manual page 30

4 Using the control module
Signals tab
Shimadzu GC-201x Setup - Signals
will be processed by Clarity. These signals will be assigned to particular
detectors (hardware) in the
Count
Defines the number of signals that will be transferred to the Clarity. These
signals correspond to Clarity detectors and will have their own sub-tabs
in the Method Setup - Acquisition
Instrument.
Ch1(..4)
Sets the name of the particular signal.
This Device Starts the Run in Clarity / Clarity Starts This Device
This radiobutton enables to start the analysis run from the Clarity . With
This Device Starts the Run in Clarity checked, the device is started prior to
Clarity by its front button or autosampler connected to this device and
passes the start to Clarity . When Clarity Starts This Device is checked,
Clarity is started prior to this device by separately wired autosampler,
Start button in Single Run or different device and then starts this device.
Note: The This Device Starts the Run in Clarity option is checked by default.
Fig 22: Shimadzu GC-201x Setup - Signals
Method Setup - GC - DET X
tab defines the number of signals that
dialog, if configured on the given Clarity
- 26 -
Clarity Controls
dialog.