Health O Meter 2500KL User Instructions page 15

2600KL ASSEMBLY INSTRUCTIONS (CONTINUED)
Assembling the 2600KL Scale (Refer to Figures 7-10)
Caution: It is recommended that the assembly be performed by two persons.
1. Remove the scale assembly from the carton by first removing the inserts, then tucking the
bag down around the end of the box, and finally tilting the carton up on its end. Carefully roll
the scale out of the carton.
2. Remove the bag from around the scale, and safely store or discard the bag.
3. Thread the (4) feet into the underside of the scale platform (see Figure 8). Each foot
should initially be completely hand tightened. Back feet out 1-½ full turns. This will allow for
proper load cell operation and scale accuracy.
4. Open the scale to its operational position.
Warning: Do not drop the scale on its feet. This can result in permanent load cell
damage.
5. Rotate the display support so that it is perpendicular to the handrail.
6. Position the display assembly close to the display support on the handrail. Connect the
load cell cable connector to the load cell port, located on the back of the display assembly.
The port is labeled "LOAD CELL" (see Figure 7).
Note: Do not attach the AC adapter power cord into the back of the display assembly at this
point.
7. Align the four mounting holes on the back of the display assembly with the four mounting
holes in the display support, and fasten the display assembly onto the metal display support
using the (4) Phillips pan head #5 x 3/8 screws (see Figure 9).
8. Place the pivot bracket screw covers over the pivot screws, and fasten the covers to the
back of the display assembly using the (4) Phillips pan head #5 x 3/8 screws.
9. Connect the AC adapter to the power port, located on the back of the display assembly.
Caution: Do not plug the scale into a power source until the scale is fully assembled.
10. Rotate the display assembly to align it parallel to the handrail, and then attach the front
and rear display support covers by applying light pressure while snapping the covers into
place.
11. Make any necessary adjustments to level the scale by turning the feet in or out.
12. The scale is now assembled. Plug the AC adapter into a power source and / or insert the
batteries.
15