Mounting The Monitor; Removing The Monitor Stand - HP S240n User Manual

Mounting the monitor

The monitor panel can be attached to a wall, swing arm, or other mounting fixture.
NOTE: This apparatus is intended to be supported by UL– or CSA–Listed wall-mount bracket.
If the monitor is TCO certified, the power cord plugged into the monitor panel must be a shielded power cable.
The use of a shielded power cable meets the TCO Certified criteria for display products. For information on
TCO requirements, go to www.tcodevelopment.com.
CAUTION: This monitor supports the VESA industry standard 100 mm mounting holes. To attach a third-
party mounting solution to the monitor, four 4 mm, 0.7 pitch, and 10 mm long screws are required. Longer
screws must not be used because they may damage the monitor. It is important to verify that the
manufacturer's mounting solution is compliant with the VESA standard and is rated to support the weight of
the monitor display panel. For best performance, it is important to use the power and video cables provided
with the monitor.

Removing the monitor stand

CAUTION: Before beginning to disassemble the monitor, be sure the monitor is turned off and all cables are
disconnected.
1. Disconnect and remove all cables from the monitor.
2. Lay the monitor facedown on a flat surface covered by a clean, dry cloth.
3. Press the release latch (1) and remove the stand from the monitor panel (2).
Setting up the monitor 11