K2600R Front Panel; Rack Models Only - Kurzweil K2600 Series Service Manual

Introduction

K2600R Front Panel

K2600R Front Panel
Chan/Bank,
Layer/Zone
buttons
Chan/Bank
Layer/Zone
Edit
LCD
Contrast
Program Setup
Mute 1 Mute 2
Zoom - Zoom +
Power
LCD
Contrast
Power
Edit
button
Figure 1-5

Rack Models only

• Power switch, push switch to turn the unit on and off.
• MIDI LED, this LED flashes when receiving data from a MIDI controller.
• Headphone jack, use this 1/4" jack to connect headphones.
• Volume potentiometer, adjusts the overall volume of the mixed audio outputs and the
headphone jack.
• LCD Contrast, turn this potentiometer to adjust the LCD for the best visibility.
• Disk Drive, use the disk drive to load, save, and copy data to a floppy disk. Use formatted
double-sided, double density (DSDD—720K or high-density (HD—1.4M) disks.
• Inputs, this section is covered by a plate if the sampling option is not installed.
1-6
LCD and
Soft buttons
(below)
MIDI LED MIDI LED
Q Access Effects MIDI Master Song
Mute 3 FX Bypass Previous Pg Mark Jump
Samp/Sec Gain - Gain + Link
Mode
buttons
Front panel, K2600RS rack model
• For units with the sampling option, use either the two Lo Z XLR or the Hi Z 1/4"
(tip/ring/sleeve) jacks for sampling from an analog source.
• Optical In, If sampling from a digital source with an optical out jack, use this input.
Alpha wheel,
Minus (–) and
Plus (+) buttons
Exit
Cursor
button
buttons
Data Entry
Exit
MIDI
Disk
Compare
MIDI LED
Disk Drive
Optical
Alphanumeric In
buttons
Inputs
Optical
1 2 3
Lo Z
ABC DEF GHI
4 5 6
JKL MNO PQR
Left
7 8 9
STU VWX YZ
+ / - 0 Clear
UPPER/lower 0-9 Space
Cancel Enter
Right
Hi Z
Left
Right
Headphone
Volume
Volume
Headphone
Inputs