Table of Contents
Advertisement
• Tinsnips to cut banding
Tools
• Stepladder
Required
• Bucket
• Level
• 1-1/2" open-end wrench
• Side panels to match cabinetry
Materials
• 2x4, 36", 42" or 48" long, for Anti-Tip support, see page 10
Required
• Special velcro adhesive strips for 1/4" side panels
Hardware
• 1/4-1/4 union with nuts
Supplied
• Water filter bypass plug
• Water shut-off valve
Hardware
Recommendations
For proper installation, this refrigerator must
Flooring
be placed on a level surface of hard material
that is at the same height as the rest of the
flooring. This surface should be strong
enough to support a fully loaded refrigerator.
1
Step
Remove
Packaging
• Remove outer carton.
• Slide out back corner posts (2).
• Slide carton off top of cabinet.
NOTE: IT IS NOT NECESSARY TO LAY
CABINET DOWN IN ORDER TO REMOVE
SKID!
• To remove skid, remove the four 7/16" bolts
• There are support blocks on the bottom of
DO NOT ATTEMPT TO ROLL UNIT OFF
SKID.
CAUTION
Refrigerator is much heavier at the top than at
the bottom – be careful when moving. When
using a hand truck, handle from side only.
PRUDENCE
Le réfrigérateur est beaucoup plus lourd en
haut qu'en bas. Il faut être prudent lors des
déplacements. Si un diable est utilisé, il faut
soulever le réfrigérateur sur le côté seulement.
–Carefully cut banding at the top and
bottom.
and their brackets.
the cabinet and door. They must be removed
before sliding unit off skid or damage will
occur.
CAUTION
Installation Preparation
• Appliance Hand Truck
• Tubing cutter
• 7/16" open-end wrench
• #2 Phillips screwdriver
• Stubby Phillips screwdriver
NOTE: Protect the finish of the flooring. Cut
a large section of the cardboard carton and
place under the refrigerator where you are
working.
• Carefully, tilt cabinet and slide blocks out
from beneath cabinet, slide unit off skid.
• Remove toekick from the fresh food com-
partment, set aside for later installation.
IL NE FAUT PAS ESSAYER DE FAIRE
ROULER LE RÉFRIGÉRATEUR POUR
L'ENLEVER DE LAY PALETTE.
Stainless Steel Built-In Refrigerators
• Drill and appropriate bits
• 7/16" socket with 3" extension
for ratchet
• Safety glasses
PRUDENCE
7/16" Bolt
7
Advertisement
Table of Contents
