HP Envy x360 m6 Series Maintenance And Service Manual page 58

h. Remove the TouchScreen board cable (6).
The TouchScreen board cable is available using spare part number 856803-001.
7. If it is necessary to replace the G-sensor board:
a. Remove the display panel assembly.
CAUTION:
clear of tools, screws, and any other foreign objects. Failure to follow this caution can result in
damage to the display panel assembly.
b. Turn the display panel assembly upside down with the bottom edge toward you.
c. Detach the adhesive support strip (1) that secures the TouchScreen board cable to the ZIF
connector on the G-sensor board.
d. Release the ZIF connector (2) to which the TouchScreen board cable is connected, and then
disconnect the TouchScreen board cable from the G-sensor board.
50 Chapter 5 Removal and replacement procedures
Before turning the display panel assembly upside down, make sure the work surface is