HP Envy x360 m6 Series Maintenance And Service Manual page 57

6. If it is necessary to replace the TouchScreen board cable:
a. Remove the display panel assembly.
CAUTION: Before turning the display panel assembly upside down, make sure the work surface is
clear of tools, screws, and any other foreign objects. Failure to follow this caution can result in
damage to the display panel assembly.
b. Turn the display panel assembly upside down with the bottom edge toward you.
c. Release the adhesive support strip (1) that secures the TouchScreen board cable to the ZIF
connector on the TouchScreen board.
d. Release the ZIF connector (2) to which the TouchScreen board cable is connected, and then
disconnect the TouchScreen board cable from the TouchScreen board.
e. Remove the tape (3) that secures the TouchScreen board cable to the display back cover.
f. Release the adhesive support strip (4) that secures the TouchScreen board cable to the ZIF
connector on the G-sensor board.
g. Release the ZIF connector (5) to which the TouchScreen board cable is connected, and then
disconnect the TouchScreen board cable from the G-sensor board.
Component replacement procedures 49