HP Envy x360 m6 Series Maintenance And Service Manual page 36

4. Remove the two Phillips M2.5×7.8 screws (2) and the six Phillips M2.0×5.2 screws (3) that secure
the bottom cover to the computer.
5. Insert a case utility tool (1) or similar plastic, flat-edged tool between the bottom cover
and the computer near the display hinge area.
6. Release the bottom cover rear edge (2) and swing it up and back until it releases.
7. Remove the bottom cover (3).
Reverse this procedure to install the bottom cover.
28 Chapter 5 Removal and replacement procedures