Getting Started; Step 1: Preparing The Remote Control; Using The Remote Control To Operate The System; Step 2: Switching On The Dvd System - Philips HTS8000S/37 User Manual

Getting Started

Step 1: Preparing the remote
control
Before you start using the remote
control, pull out the plastic protective
sheet.
To change the battery
G
Pull out the battery compartment and
replace with the battery type LITHIUM
CR2025.
CAUTION!
– Remove battery if it is exhausted
or if the remote control is not to be
used for a long time.
– Batteries contain hazardous
chemical substances, so they should
be disposed of properly.
20
001-053-hts8000-37-Eng14a
Using the remote control to
operate the system
1
Aim the remote control directly at the
remote sensor (iR) on the front panel.
2
Press SOURCE button on the remote
to select the mode you wish to control
(for example TV, DISC.) The selected
source mode will light up on the LED
panel for a few seconds.
3
Then select the desired function (for
example É, S, T.)
Step 2: Switching on the
G
Press SOURCE button repeatedly to
select :
Switching to Eco Power standby
mode
G
Press STANDBY ON (B.)
➜
➜
in red.
20
DVD system
DISC ™ TUNER FM ™ TV ™ AUX
™ DI ™ DISC ....
The display screen will go blank.
The Eco Power indicator will light up
7/2/05, 10:20 AM
3139 115 2xxx1