Getting Started; Step 1: Inserting Batteries Into The Remote Control; Using The Remote Control To Operate The System; Step 2: Setting The Tv - Philips LX8500W/69 User Manual

Step 1: Inserting batteries into
the remote control
1
Open the battery compartment.
2
Insert two batteries type R06 or AA,
following the indications (+-) inside
the compartment.
3
Close the cover.
Using the remote control to operate
the system
1
Aim the remote control
directly at the remote
sensor (iR) on the front
panel.
2
Press SOURCE button
on the remote to select
the mode you wish to
control (for example TV,
DISC). The selected
source mode will light
up on the LED panel for
a few seconds.
3
Then select the desired
function (for example
É, S, T).
CAUTION!
– Remove batteries if they are
exhausted or if the remote is not to
be used for a long time.
– Do not use old and new or
different types of batteries in
combination.
– Batteries contain chemical
substances, so they should be
disposed of properly.
001-045-LX85-69-Final

Step 2: Setting the TV

IMPORTANT!
Make sure you have completed all
the necessary connections. (See
page 9 "Connecting TV")
1
Press SOURCE control until "
appears on the display panel.
2
Turn on the TV and set to the correct
video-in channel. You should see the blue
DVD background screen on the TV.
➜
Usually this channel is between the
lowest and highest channels and may be
called FRONT, A/V IN, VIDEO. See your
TV manual for more details.
➜
Or, you may go to channel 1 on your
TV, then press the Channel down button
repeatedly until you see the Video In
channel.
➜
Or, the TV remote control may have a
button or switch that chooses different
video modes.
17

Getting Started

DISC
"
24/08/2004, 10:54 AM 3139 115 23231
17