Tektronix 7B92A Maintenance Manual page 53

Description
12. Cable
13. Cable
14. Screwdriver
15. Low Capacitance'
Screwdriver
1
Used for calibration only; NOT used for performance check.
2
Requires a TM 500-Series Power Module.
@
Minimum Specifications
Impedance, 50 0; type RG-58/U;
length, 18 inches; connectors,
bnc.
Impedance, 50 0; type RG-58/U,
length 42 inches; connectors, bnc.
Three-inch shaft, 3/32 inch bit.
1-1/2 inch shaft.
Table 5-1. (cont)
Purpose
Used throughout procedure
for signal interconnection.
Used throughout procedure
for signal interconnection
Used to adjust variable
resistors.
Used to adjust variable
capacitors
5-3
Performance Check/Calibration-7B92A
Examples of Applicable
Test Equipment
Tektronix Part No.
0076-00.
Tektronix Part No.
0057-01.
Xcelite R-3323.
Tektronix Part No. 003-
0000-00.
012-
012-