Adjustment After Repair; Repackaging For Shipment - Tektronix 7B92A Maintenance Manual

9. To replace the triggering switches, reverse the
above procedure.

ADJUSTMENT AFTER REPAIR

After any electrical component has been replaced,
the adjustment of that particular circuit should be
checked, as well as other closely related circuits. See
Adjustment section
procedure.

REPACKAGING FOR SHIPMENT

If the Tektronix instrument is to be shipped to a
Tektronix Service Center for service or repair, attach a
tag ;showing: owner (with address) and the name of an
individual at your firm that can be contacted, complete
instrument serial number, and a description of the
service required.
REV C, JUN 1978
for a complete adjustment
Save and re-use the package in which your
instrument was shipped. If the original packaging is unfit
for use or not available, repackage the instrument as
follows:
1. Obtain a carton of corrugated cardboard having
inside dimensions of no less than six inches more
than the instrument dimensions; this will allow for
cushioning. Refer to the following table for carton
test strength requirements.
2. Surround
sheeting to protect the finish of the instrument.
3. Cushion the instrument on all sides by tightly
packing dunnage or urethane foam between
carton and instrument, allowing three inches on all
sides.
4. Seal carton with shipping tape or industrial stapler.
SHIPPING CARTON TEST STRENGTH
Gross Weight (lb)
0-10
10-30
30-120
120-140
140-160
4-11
Maintenance-7B92A
the instrument with
Carton Test Strength (lb)
200
275
375
500
600
polyethylene