Lencore Spectra i.Net Installation And Operation Manual page 23

section 5
5.5 | wiring the speakers and i.Net
First, run power cables to the IN/OUT connections of each i.Net OP,
1
taking care to be consistent with positive and negative screw terminals.
Do NOT cross positive and negative connections while wiring power- irreversible
damage will occur.
Run the power cables (NOT LIVE) from the power supply unit in the electrical/ IT
2
closet to the power +/- screw terminal connections of the first i.Net OP.
Complete all other wiring (audio and data) and perform wiring checklist
3
BEFORE powering up the system.
WARNING
NOTE: Make sure that grounds are connected to grounds and positives
to positives, and that wires are not crossed anywhere in the entire system.
Double check the wiring at each power supply.
Follow all labeling for power.
®
ops
19