Static Routing Rules - Delta DX-2300 Series User Manual

DX - 2 3 00 Ser i es I nd us t r i al Et h er ne t C lo u d Ro ut er
indefinitely. It allows for a mechanism to gracefully reuse DHCP addresses.
Options here are 1 to 3 days.
First IP Address
To increase the number of addresses available to clients, you can change
the Start Address.
Last IP Address
To increase the number of addresses available to clients, you can change
the End Address.
_3
STP
STP is a network protocol that builds a logical loop-free topology for Ethernet
networks. The basic function of STP is to prevent bridge loops and
the broadcast radiation that results from them. If this STP is enabled, the
traffic usage will increase about 15Mbit in 24 hours.
3.2.3

Static Routing Rules

This page is used for setting up the Static Routing, including the Rule Name, Network Interface, Enabled, Destination IP,
Network Mask, Gateway Address and Metric. Click the "Add A Rule" to add static routing rules.
After clicking the "Add A Rule", you will see the following page.
3 - 1 0
Description Default
192.168.1.100
192.168.1.200
Disable