Nice Neostar A Installation And Use Instructions And Warnings page 4

3) Adjustments
The NEOSTAR series tubular motors are equipped with an electron-
ic limit switch that interrupts the power supply when the awning or
shutter reaches the opening or closing limit. These two limits must
be programmed into the memory after the motor has been installed
and the shutter/awning mounted. The motor can still be command-
ed even if these two travel limits, (hereinafter referred to as "position
0" and "position 1") have not yet been memorised; however, the
4) Programming
A reverser switch, enabling the simultaneous activation of both elec-
tric motor phases, must be used to program the travel limits.
The special TTU control unit can be used for this purpose. Button ▲
is used to raise the shutter/awning; button ▼ is used to lower it.
Table "A1" Programming the "0" and "1" positions (fig. 7)
Press and hold down the ▲ control to raise the shutter.
1.
Release the ▲ control when the shutter has reached "Position 0".
2.
Operate the ▲ and ▼ controls as many times as necessary to adjust the position.
Press and hold down the ▲ and ▼ controls simultaneously.
3.
4. Wait approximately 3 seconds for the shutter to move briefly down and up.
Release the ▲ and ▼ controls.
5.
Press and hold down the ▼ control to lower the shutter.
6.
Release the ▼ control when the shutter has reached "Position 1".
7.
Operate the ▲ and ▼ controls as many times as necessary to adjust the position.
Press and hold down the ▲ and ▼ controls simultaneously.
8.
9. Wait approximately 3 seconds for the shutter to move briefly up and down.
Release the ▲ and ▼ controls.
10.
If the motor is moved after programming, the memorized positions must be erased:
Table "A2" Erasing the "0" and "1" positions (fig. 8)
Press and hold down the ▲ and ▼ up and down controls simultaneously.
1.
2. it approximately 3 seconds for the shutter to move briefly up and down.
3. Release one of the buttons (▼, for example) while still pressing the other one.
4. Press and release the button (released at step 3) three times within 3 seconds from the time
the shutter moved up and down momentarily.
5. Release the other button as well.
4
Position 0
movement in this case will be interrupted twice, momentarily, at the
start of each manoeuvre, and will then continue unimpeded and
uncontrolled. If only one travel limit has been memorized, the move-
ment will be interrupted only once, momentarily, at the start of each
manoeuvre, and will then continue unimpeded and uncontrolled.
Position 1
If the movement is reversed exchange the two motor phases.
Example
3s
3s
Example
3s
x3