28
Self Check
When a radio unit is turned on, a self check program is started automatically.
If no failures occur then all segments of the display on the front panel are turned on. A short beep
indicates that the self check test has been completed without a failure.
Self check takes approximately 1 second.
After the test radio unit displays its own ID for approximately 1 second and switches to normal oper-
ation.
Error Codes
If the radio unit fails in the self check routine, an error code is shown on the display and a alert beep
is played.
Table 2. Error codes
Native data prog. error
Radio config. prog. error
Security prog. error
CM5000 Mobile Repeater/Gateway - Basic Service Manual
Error Code
Description
Programming data error
Radio configuration programming error
Security data programming error
TEST SETUP & ADJUSTMENT