Motorola Cleartone CM5000 Basic Service Manual page 10

x
Mobile Antenna Installation Guidelines
• These mobile antenna installation guidelines are limited to metal body motor vehicles or vehicles
with appropriate ground planes.
• Antennas should be installed in the centre area of the roof or the trunk lid taking into account the
bystander exposure conditions of backseat passengers and according to the specific instructions
and restrictions in the Radio (Terminal) Installation Manual along with the requirements of the
antenna supplier.
• Trunk lid installations are limited to vehicles with clearly defined flat trunk lids, and in some
cases, to specific terminal models and antennas. See the Radio (Terminal) Installation Manual
for specific information on how and where to install specific types of approved antennas to
facilitate recommended operating distances to all potentially exposed persons.
• Use only Motorola-approved supplied antenna or a Motorola approved replacement
antenna. Unauthorised antennas, modifications, or attachments could damage the terminal and
may result in non-compliance with RF Safety Standards.
Approved Accessories
• This terminal has been tested and meets the RF Safety Standards when used with the Motorola
accessories supplied or designated for this product. Use of other accessories may result in non-
compliance with RF Safety Standards.
• For a list of Motorola approved antennas, please see your dealer or local Motorola contact. Your
nearest dealer can be found at the following web site:
http://www.motorola.com/businessandgovernment/wemea/en-gb/public/functions/dealerlocator/
dealerlocator.aspx
Additional Information
• For additional information on exposure requirements or other training information, visit
http://www.motorola.com/rfhealth
Compliance and Control Guidelines and Operating Instructions for Mobile
Two-Way Terminals Installed as Fixed Site Control Stations
If mobile terminal equipment is installed at a fixed location and operated as a control station or as a
fixed unit, the antenna installation must comply with the following requirements in order to ensure
optimal performance and compliance with the RF energy exposure limits in the standards and
guidelines listed on previous page:
• The antenna should be mounted outside the building on the roof or a tower if at all possible.
CM5000 Mobile Repeater/Gateway - Basic Service Manual Product Safety and RF Exposure