Find The Tv Input Channel; Select A Menu Display Language; Turn On Progressive Scan - Philips DVP3526 User Manual

Note
•
If you are not going to use the remote control for a long
time, remove the batteries.
•
Do not mix batteries (old and new or carbon and
alkaline, etc.).
•
Batteries contain chemical substances, so they should be
disposed of properly.

Find the TV input channel

1
Press to turn on this product.
2
Turn on the TV and switch to the video input
channel (refer to the TV user manual on how
to select the A/V input channel).

Select a menu display language

1
Press SETUP.
» [General Setup] menu is displayed.
2
Select [OSD Language], and then press .
3
Press to select a language, and then press
OK.

Turn on progressive scan

Note
•
To use the progressive scan feature, you must connect a
progressive scan TV with the component video jacks (see
"Connect" > "Connect audio/video cables" > "Option 1:
Connect to the component video jacks" for details).
8 EN
1
Turn on the TV to the correct viewing channel
for this product.
2
Press SETUP.
3
Press to select [Video Setup].
4
Select [Progressive] > [On], and then press
OK.
»
A warning message is displayed.
5
To proceed, select [Ok] and then press OK.
»
The progressive setup is complete.
Note
•
If a blank/distorted screen is displayed, wait for 15
seconds for the auto recovery.
•
If no picture is displayed, turn off the progressive scan
mode as follows:
1) Press to open the disc compartment.
2) Press the Numeric button '1'.
6
Press SETUP to exit the menu.
7
You can now turn on the progressive scan
mode on the TV (see the TV user manual).
Note
•
During play, when the progressive scan mode is on for
both this product and the TV, distorted picture may
display. In this case, turn off the progressive scan feature
on both this product and the TV.