Table of Contents
Advertisement
Connect USB fl ash drive
DVD PLAYER DVP3568
1
Connect a USB fl ash drive to the
this product.
Note
•
This product can only play/view MP3, WMA, DivX
(Ultra) or JPEG fi les that are stored on a USB fl ash drive.
•
Press the
button to access the content and play
the fi les.
Connect power
Caution
•
Risk of product damage! Ensure that the power supply
voltage corresponds to the voltage printed on the back
of the product.
•
Before connecting the AC power cord, ensure you have
completed all other connections.
Note
•
The type plate is located on the back of the product.
1
Connect the AC power cable to the wall
socket.
»
The product is ready to be set up for use.
4 Get started
Prepare the remote control
1
Press and push the battery compartment to
slide it open (see "1" in the illustration).
2
Insert two AAA batteries with correct
polarity (+/-) as indicated.
3
Push and slide back the battery compartment
(see "3" in the illustration).
8
EN
jack on
•
If you are not going to use the remote control for a long
time, remove the batteries.
•
Do not mix batteries (old and new or carbon and
alkaline, etc.).
•
Batteries contain chemical substances, so they should be
disposed of properly.
Find the TV input channel
1
Press
2
Turn on the TV and switch to the video input
channel (refer to the TV user manual on how
to select the A/V input channel).
Select menu display language
•
If this product is connected to a HDMI CEC compliant
TV, skip this setting. It switches automatically to the
same OSD menu language as per your TV setting (if the
language set on TV is supported by this product).
1
Press SETUP.
» [General Setup] menu is displayed.
2
Select [OSD Language], and then press .
3
Press
press OK.
Note
to turn on this product.
Note
to select a language, and then
Advertisement
Table of Contents
