Table of Contents
Advertisement
4 Get started
Prepare the remote control
1
Press and push the battery compartment to
slide it open (see "1" in the illustration).
2
Insert two AAA batteries with correct
polarity (+/-) as indicated.
3
Push and slide back the battery compartment
(see "3" in the illustration).
Note
•
If you are not going to use the remote control for a long
time, remove the batteries.
•
Do not mix batteries (old and new or carbon and
alkaline, etc.).
•
Batteries contain chemical substances, so they should be
disposed of properly.
Find the TV input channel
1
Press
to turn on this product.
2
Turn on the TV and switch to the video input
channel (refer to the TV user manual on how
to select the A/V input channel).
Select a menu display language
Note
•
If this product is connected to a HDMI CEC compliant
TV, skip this setting. It switches automatically to the
same OSD menu language as per your TV setting (if the
language set on TV is supported by this product).
9
EN
1
Press SETUP.
» [General Setup] menu is displayed.
2
Select [OSD Language], and then press .
3
Press
to select a language, and then press
OK.
Turn on progressive scan
Note
•
To use the progressive scan feature, you must connect a
progressive scan TV with the component video jacks (see
"Connect" > "Connect audio/video cables" > "Option 2:
Connect to the component video jacks" for details).
1
Turn on the TV to the correct video input
channel for this product.
2
Press SETUP.
3
Press
to select [Video Setup].
4
Select [Progressive] > [On], and then press
OK.
»
A warning message is displayed.
5
To proceed, select [Ok] and then press OK.
»
The progressive setup is complete.
Advertisement
Table of Contents
