Connecting The Video Component - Onkyo TX-NR901 Instruction Manual

Using the Remote Controller with Other Components—Continued
Learning Commands from Another
Remote Controller
You can teach the TX-NR901's remote controller new
commands simply by transmitting commands from
another remote controller one at time. For example, by
transmitting the Play and Stop commands from your CD
player's remote controller, the TX-NR901's remote con-
troller can be taught to transmit those commands when
its Play [ ] and Stop [ ] buttons are pressed in CD
mode.
1
Press and hold the [CUSTOM]
button for more than three sec-
onds.
The remote controller enters Custom
mode.
2 Roll the scroll wheel to select
LEARN, and then press the scroll
wheel.
3
Roll the scroll wheel to select the
the remote controller mode you
want to teach a new command,
and then press the scroll wheel.
The following remote controller modes
can be selected: DVD, TV, VCR, CBL,
or SAT.
4
On the TX-NR901's remote con-
troller, press the button you want
to teach the new command.
If you press a button that cannot be
taught a new command, the message
"RETRY" appears and you should
press another button.
94
5 Point the remote controllers at
each other, about 2 to 6 inches
(5–15 cm) apart, and then, on the
other remote controller, press the
button whose command you
want to learn.
When the command has been learnt
successfully, "OK" appears on the dis-
play. You may need to press the button
several times.
If the command is not learnt success-
fully, after the message "FAIL" has
been displayed, the mode select display
reappears (step 3), and you should try
again.
6
To teach the TX-NR901's remote
controller more new commands,
repeat steps 3 through 5.
Press the [CUSTOM] button when
you've finished.
Note:
• The following buttons cannot be taught new com-
mands: [LIGHT], [CUSTOM], [MACRO], [MODE],
[INPUT], [ZONE 2], and the scroll wheel button.