Extron electronics SMP 351 Setup Manual page 5

I ADJUST knobs — Rotary controls used with the MENU and NEXT buttons to change settings in configuration
menus (see figure 4 on page 3).
J
I/O display LEDs — A stack of four green LEDs that correspond to the four digital I/O connections on the rear
figure 1
panel (see on page 1). Each LED indicates the on or off status of the corresponding ports. Each port can
be configured as digital input or digital output.
Mode
Digital input
Digital output
Powering Up
When applying power, the unit undergoes a self-testing sequence (see figure 5 and 6, below). After the testing
sequence is complete (and when the device is not being configured), the default display cycle is shown on the
LCD display (below, right).
The default display cycle shows the selected inputs and their resolutions, stream mode and output resolution.
During recording, two additional items are added to the default cycle with the current length of the recording and
time remaining.
2
EXTRON
Power sec.
ELECTRONICS SMP 35x FW V1.06
On
~4
sec.
30
LOADING
sec.
FIRMWARE
Default Display Cycle for Composite mode
Figure 5.
2
EXTRON
Power sec.
ELECTRONICS SMP 35x FW V1.06
On
~4
sec.
30
LOADING
sec.
FIRMWARE INITIALIZING
NOTES:
• The information shown in the default display cycle differs
depending on the active input and the type of video signal.
• Time Record and Time Remain display only during a recording.
Default Display Cycle for Dual Channel Mode
Figure 6.
The SMP 300 Series models contain several primary configuration menus available from the front panel LCD
display. Press MENU to advance through the configuration menus in the order shown below.
Menu
PICTURE
PRESETS
CONTROL
Menu Menu
EXIT MENU?
PRESS NEXT
Within each primary menu are submenus with specific configuration options. Stop on a primary menu, then
press NEXT to enter the submenus for the selected configuration.
Use the ADJUST knobs (see
parameter, press NEXT to enter the new parameter and move to the next submenu, or press MENU to enter the
new parameter and return to the primary menu.
NOTE: The front panel buttons on the SMP models can be locked so that configuration using the front panel is
not possible (see "Executive Mode" in the SMP 300 Series User Guide).
LED Off
Port input is above the threshold.
Port output is off.
EXTRON
45
SMP 35x
sec.
INITIALIZING
EXTRON
45
SMP 352
sec.
Menu Menu
RECORD/STREAM
CONFIGURATION
Menu
VIEW COMM
STATUS
SETTINGS
figure 4, on page 3) to change the submenu settings. After selecting new
I
,
LED On
Port input is below the threshold.
Port output is on.
Default Display Cycle
In 1 1024x768@60
In 3 720p@60
2 sec.
TIME REMAIN
HH:MM:SS
Default Display Cycle
2
In 1 1024x768@60
sec.
In 3 720p@60
2 sec.
2
sec.
TIME REMAIN
HH:MM:SS
Menu
INPUT BACKGROUND
CONFIGURATION RECALL
(Composite mode only)
Menu
ADVANCED
CONFIGURATION
2
sec. ARCHIVE 5.0 MB
1280x720@30 fps
2 sec.
2
sec.
TIME RECORD
HH:MM:SS
CHA 5.0 MB
2 sec.
1280x720@30 fps
CHB 5.0 MB
2 sec.
1280x720@30 fps
TIME RECORD
2 sec.
HH:MM:SS
Menu
5