Sony DFW-V500 Manual page 33

COMMAND SETTING AND OPERATION TIMING
Trigger Mode command and actual operation timing
It takes at least about 1 V for external trigger signals to be received (Trigger Mode) after the Trigger ON command has been
set to the CSR (F0F00830h) of the camera during the isochronous output of the moving image. (VDs are the reference signals
inside the camera and cannot be observed from outside the camera.)
External trigger signal inputs during the isochronous transmission will not be accepted. Input external trigger signals after the
isochronous transmission completes.
Set Trigger ON in this period
VD
1 V = 33.33 ms
SG
Image Readout
Isochronous
VD
SG
Image Readout
Isochronous
VD
SG
Image Readout
Isochronous
Image Readout
When Frame Rate is 30 Frame/s
Set Trigger ON in this period
Set Trigger ON in this period
When Frame Rate is 7.5 Frame/s
External trigger signal can be
input from here
Isochronous output ends
Image Readout
External trigger signal can be
input from here
DFW-V500
DFW-VL500
External trigger
signal can be
input from here
31