Sony DFW-V500 Manual page 19

SETTINGS OF CAMERA CONTROL AND STATUS REGISTER
CSR F0F0080Ch White Balance
Adjust the red and blue gains to properly capture white subjects in color. Two types of automatic adjustment modes are
available.
NOTE
: If the CSR F0F00830h Trigger is set to ON or if the CSR F0F0081Ch Shutter setting is less
than 800h, the Auto function cannot be used.
The CSR F0F0088Ch Optical Filter is canceled by this command. (Priority to latter)
(1) Manual adjustment
Command = 820mm0nnh
(2) One-Push Auto White Balance
Perform automatic adjustment when command is received to maintain the white balance at that time.
Execute: Command = 86∗∗∗∗∗∗h
When this operation is complete, the command is read out as 82∗∗∗∗∗∗h (∗∗∗∗∗∗: Undefined).
NOTE :
(3) Auto Tracing White Balance
Perform automatic adjustment continuously to trace the white balance according to changes in the shooting
conditions.
ON : Command = 83∗∗∗∗∗∗h
OFF : Set the command of (1) or (2).
NOTE
:
CSR F0F00810h Hue
Adjust the hue of the image.
Command = 820000nnh
CSR F0F00814h Saturation
Adjust the saturation of the image.
Command = 820000nnh
Execute after capturing a white subject lit using the light source used for shooting
over the whole screen at the appropriate exposure. It will take a maximum of 10
seconds to complete automatic adjustment.
Execute again if the light source used for shooting has been changed.
Operations stop if the exposure is inappropriate.
When the area of the white subject in the screen is small, adjustment accuracy will
drop.
mm: Adjust B-gain in the range of 01h (min) – FFh (max).
nn : Adjust R-gain in the range of 01h (min) – FFh (max).
80h is the standard value.
∗∗∗∗∗∗: Undefined
∗∗∗∗∗∗: Undefined
nn: Adjust in the range of 00h (Skin Tone → Red) – FFh
(Skin Tone → Yellow).
80h is the standard value.
nn: Adjust in the range of 00h (light) – FFh (deep).
80h is the standard value.
DFW-V500
DFW-VL500
17