Sony DFW-V500 Manual page 25

COMMAND SENDING PROCEDURE UNTIL IMAGES ARE DISPLAYED
(2) Acquiring the format/mode/frame rate
a) Check available formats
Refer to the Inquiry register for video format and check the available formats.
Address
F0F00100H
As bit 0 is set, it means that Format0 is available.
b) Check available video modes
Refer to Inquiry register for video mode, and check which video mode in Format0 is available.
Address
F0F00180H
As bits 0, 1, 2, and 3 are set, it means that Mode0, Mode1, Mode2, and Mode3 are available.
c) Check available frame rates (Example: Mode3)
Address
F0F0020CH
As bits 1, 2, 3, and 4 are set, it means that 3.75 fps, 7.5 fps, 15 fps, and 30 fps are available.
(3) Video transmission start command
When the following values are set for Status and Control registers for the camera, the camera starts video transmission.
(Example: Video Format = 0, Video Mode = 3, Frame Rate = 30 fps, ISO Speed = 400M bps)
Address
F0F00600H
F0F00604H
F0F00608H
F0F0060CH
F0F00614H
To stop the video, set the ISO Enable bit to 0.
Address
F0F00614H
Action Data
Read 80000000H
Action Data
Read F0000000H
Action Data
Read 78000000H
Action Data
Write 80000000H
Write 60000000H
Write 00000000H
Write 02000000H
Write 80000000H
Action Data
Write 00000000H
Frame Rate = 30 fps
Video Mode = 3
Video Format = 0
ISO ch = 0, Speed = 400M bps
ISO Enable ON
ISO Enable OFF
DFW-V500
DFW-VL500
23