Mitsubishi Electric PUZ-A12NKA7 Service Manual page 43

Phenomena
6. Remote controller display works
normally and the unit performs cool-
ing operation, however, the capacity
cannot be fully obtained. (The air
does not cool well.)
7. Remote controller display works
normally and the unit performs heat-
ing operation, however, the capacity
cannot be fully obtained.
8. 1 F or 3 minutes after temperature
adjuster turns off, the compressor
will not start operating even if
temperature adjuster is turned on.
2 F or 3 minutes after temperature
adjuster turns on, the compressor
will not stop operating even if
temperature adjuster is turned off.
(Compressor stops operating
immediately when turning off by
the remote controller.)
OCH636A
Factor
1 Refrigerant shortage
2 Filter clogging
3 Heat exchanger clogging
4 Air duct short cycle
1 Linear expansion valve fault
Opening cannot be adjusted well due to linear
expansion valve fault.
2 Refrigerant shortage
3 Lack of insulation for refrigerant piping
4 Filter clogging
5 Heat exchanger clogging
6 Air duct short cycle
7 Bypass circuit of outdoor unit fault
12 Normal operation
(For protection of compressor)
43
Countermeasure
1 If refrigerant leaks, discharging
temperature rises and LEV opening
increases.
Inspect leakage by checking the
temperature and opening.
Check pipe connections for gas leakage.
2 Open intake grille and check the filter.
Clean the filter by removing dirt or dust on
it.
3 If the filter is clogged, indoor pipe
temperature rises and discharging
pressure increases. Check if heat
exchanger is clogged by inspecting
discharging pressure.
Clean the heat exchanger.
4 Remove the blockage.
1 Discharging temperature and indoor heat
exchanger temperature does not rise.
Inspect the failure by checking discharging
pressure.
Replace linear expansion valve.
2 If refrigerant leaks, discharging temperature
rises and LEV opening increases.
Inspect leakage by checking the tempera-
ture and opening.
Check pipe connections for gas leakage.
3 Check the insulation.
4 Open intake grill and check the filter. Clean
the filter by removing dirt or dust on it.
5 If the filter is clogged, indoor pipe tempera-
ture rises and discharging pressure increas-
es. Check if heat exchanger is clogged by
inspecting discharging pressure.
Clean the heat exchanger.
6 Remove the blockage.
7 Check refrigerant system during operation.
12 Normal operation