Mitsubishi Electric PUZ-A12NKA7 Service Manual page 108

OPERATING PROCEDURE
12. Removing the compressor (MC)
(1) Remove the service panel. (See Photo 2)
(2) Remove the top panel. (See Photo 1)
(3) Remove the front panel. (See Photo 1)
(4) Remove the back panel. (See Photo 1)
(5) Remove the electrical parts box. (See Photo 5)
(6) Remove the thermistor <Discharge> (TH4) and ther-
mistor <Comp. surface> (TH32). (See Photo 8)
(7) R emove 3 separator fixing screws (4 × 10) and remove
the separator.
(8) R emove the compressor body felt and compressor
shell felt.
(9) Cutting the band and remove the rubber mount.
(10) Recover refrigerant.
(11) R emove 3 compressor fixing nuts by using a spanner
or a adjustable wrench.
(12) Remove the welded pipe of compressor inlet and outlet.
Note: Recover refrigerant without spreading it in the air.
13. Removing the power receiver
(1) Remove the service panel. (See Photo 2)
(2) Remove the top panel. (See Photo 1)
(3) Remove the front panel. (See Photo 1)
(4) Remove the back panel. (See Photo 1)
(5) Remove the electrical parts box. (See Photo 5)
(6) Recover refrigerant.
(7) Remove 4 welded pipes of power receiver inlet and
outlet.
(8) Remove 2 receiver leg fixing screws (4 × 10).
(9) Remove the power receiver together with the receiver
leg.
Note: Recover refrigerant without spreading it in the air.
OCH636A
PHOTOS
Photo 12
Compressor
shell felt
Compressor
(MC)
Compressor
body felt
Separator
Separator
fixing screw
Photo 13
Outlet
108
Rubber
mount
Band
Compressor
fixing nut
Inlet
Power
receiver
Valve bed
Receiver leg
fixing screw