HYOSUNG RT125D Service Manual page 74

When fitting the kick starter to the shaft, be sure to
align the punched marks..
Fit the spring and washer on the shaft. Then, insert
the kick starter shaft into the crankcase. Engage the
pawl of kick starter guide
When fitting the kick return spring, hook the part
return spring into the crankcase, turn it 1/2 a turn
clockwise with the pliers and fit the part
spring into hole of the kick shaft. Then, fit the spring
guide and circlip.
CRANKCASE
When reassembling the crankcase pay attention to the
following.
Coat SUPER GREASE A to the lip of oil seals.
SUPER GREASE A
Remove sealant material on the fitting surface of right
and left halves of the crankcase and thoroughly
remove oil stains.
Fit the dowel pins on the half.
Apply engine oil to the big end of the crankshaft con-
rod and all parts of the transmission gears.
Apply BOND 1215 uniformly to the fitting surface of
the left half of the crankcase, and after waiting a few
minutes, fit the right half on the left half.
.
of
of return
ENGINE
3-38