How To Change Swing Motor; Swing Switch And Wiring Connector; Swing Motor And Swing Motor Wheel; Swing Motor Wiring Connection - Honeywell CO60PM Service Manual

2.5 How To Change Swing Motor

Remove the back panel follow the procedure 2.1.1
Remove the right side panel follow the procedure 2.1.3
Remove the switch box follow the procedure 2.2.1
2.5.1

Swing Switch And Wiring Connector.

Use screw driver to remove 2
galvanized screws (ST3X10) on
swing switch of the control
panel.
2.5.2

Swing Motor And Swing Motor Wheel.

Use screw driver to remove 2
galvanized screws(ST4X12) on
swing motor.
Remove the swing motor
wheel.
2.5.3

Swing Motor Wiring Connection

Swing motor wiring connection refers to part 4.2 Wiring Color Description.
Website:
Remove the pink wire on the
swing switch.
Remove the swing motor.
Get the swing motor.
15
CONFIDENTIAL
http://www.honeywellaircoolers.com
Remove the wiring cap (below
picture shown).
Note: connection is between
swing motor and N wire of
power cord.
Use screw driver to remove 1
galvanized screw(ST3*8) on the
swing motor wheel.