Table of Contents
Advertisement
1. Remove the two
screws on the
battery compart-
ment.
2. Pull out the
battery compart-
ment.
3. Remove the old
battery (please observe the dispos-
al notes on page 5).
4. Place the new battery into the
battery compartment so that the
positive pole (+) is pointing down.
5. Slide the battery compartment
with the battery facing up into the
remote control.
6. Screw the two screws back in place.
Loading new system
software
1. Download the new system software
from our website
www.teufelaudio.com/software-
updates.html.
2. Once downloaded, unpack the file
to a USB stick (FAT32 format).
9
3. Switch the Cinebar Trios (CS 42) off
with the POWER switch (9) ("OFF"
position).
4. Insert the USB stick in the SERVICE
USB port (13) on the bottom of the
device.
5. Switch the Cinebar Trios (CS 42) on
with the POWER switch (9) ("ON"
position).
The device will now load the new
firmware from the USB stick. The
indicators (5) and (6) will slowly
pulse in red.
This process will take several
minutes and must not be inter-
rupted!
Do not disconnect the device from
the mains and do not pull out the
USB stick.
6. The device will switch to standby
once the software has been in-
stalled.
7. Pull out the USB stick.
8. Switch the Cinebar Trios (CS 42)
back on. The new firmware is now
active.
13
6
5
• Cinebar Trios (CS 42)
31
Advertisement
Table of Contents
