Scientific Atlanta Continuum DVP eXtra Dense QAM Array 24 Configuration Manual page 49

8 In the RF Output drop down box, select Enable or Disable to switch on or off the
RF output.
9 In the Lower Channel Signal Format or Upper Channel Signal Format drop
down box, select the signal format for the channel in question. Perform this step
for both RF outputs.
10 In the PRBS Stuffing drop down box of the QAM card in question, select Enable
or Disable. Perform this step for both RF outputs.
11 In the Interleaving drop down box of the QAM card in question, select the
interleaving type.
12 Press the Apply command button to confirm or the Reload command button to
abort the operation.
Perform this procedure for all Quad Channel QAM Cards.
4018055 Rev B
Configuring the Quad Channel QAM Card
35