Copy Cutting - Festool OF 2200 EB Instruction Manual

Fine adjustment
11.1 11.2
The distance X (fi g. 10) of the router to the guide
rail can be set fi nely using the fi ne adjustment
(Accessories).
– Fit the fi ne adjustment (11.5) between the router
and guide stop (11.4) on the guide bars.
– Insert the adjusting wheel (11.2) for the fi ne
adjustment in the recesses of the fi ne adjust-
ment and guide stop, and screw the thread of
the adjusting wheel approximately half way into
the nut of the fi ne adjustment.
– To set, close the rotary knob (11.3) of the fi ne
adjustment and open the rotary knob (11.1) of
the guide stop.
– After making the setting, close the rotary knob
(11.1) of the guide stop.

Copy cutting

A copying ring or the copying device is used to ex-
actly reproduce existing workpieces (both available
as accessories).
a) Copying ring
– Secure the copying ring (12.1) to the router base
by inserting both tenons (12.2) into the recesses
(12.3).
– To loosen the copying ring, press both buttons
(12.4) inwards simultaneously.
When choosing the size of the copying
ring make sure that the cutter used fi ts through the
ring's opening.
The distance Y between the workpiece and template
is calculated by Y = 1/2 (Ø copying ring - Ø cutter)
11.3
11.4
11.5
b) Copying device
The angle arm WA-OF and copier scanning set
KT-OF, consisting of roller holder (13.5) and three
copying rollers (13.6), are required for the copying
device.
13.1
13.2
13.3
13.4
WA-OF
– Screw the angle arm at the desired height in the
platen's threaded bore (13.1) with the rotating
knob (13.2).
– Fit a copying roller in the roller holder and bolt
this to the angle arm with the rotating knob
(13.4). Make sure that the copying roller and
cutter have the same diameter!
– Turn the adjusting wheel (13.3) to adjust the dis-
tance between the copying roller and cutter axis.
13
12.1
12.2
12.3
12.4
13.6
13.5
KT-OF