Connecting To The Rm-930 Remote Control Unit - Sony DXC-970MD Instructions For Use Manual

Connecting to the RM-930 Remote Control Unit

DXC-970MD
MENU FUNCTION DATA
FLASH
UP LENS
WHITE
BARS
DOWN
CCU
RGB/SYNC
VIDEO OUT
REMOTE
DC IN/ GEN LOCK
REMOTE
DC IN/
REMOTE
a)
Camera cable (CCMC cable)
Notes
• When using the RM-930, use the camera cables as shown
in the table on the right.
• When using the MONITOR OUT connector of the RM-
930, set D-sub out to VBS on the on-screen menu.
Setting functions not available in the CCU-M5
Switch on the power to the CCU while pressing the
function up button on the camera. This will allow you to
make settings in the camera menu. After you have made the
75Ω coaxial cable
RM-930 remote
MONITOR OUT
control unit
DC IN
CAMERA
Composite
video input
1
Set the MODE selector
to the "1" position.
2
CAMERA
(4-pin or 12-pin)
Camera cable b)
settings, switch the CCU off and then back on again. You
will then be able to control the camera from the CCU.
a)
Camera cable
CCMC-12P02/05/10
CCMC-12P25
Video monitor,
VCR, etc.
CMA-D2MD
camera adaptor
AC IN
Power cord
b)
Camera cable
CCMC-12P02/05/10/25
CCDC-5/10/25/50A
CCMC-12P02/05/10
CCDC-5/10/25/50A
79