daltile DAD2 Operating Manual page 6

TOOL MAINTENANCE.
●
It is important to keep tools clean and
in good working order. This will result in
optimal performance of the machine.
Always follow the maintenance
instructions for proper tool maintenance.
REDUCING ACCIDENTAL STARTING OF
●
MACHINE
It is important to be sure that
the switch is in the OFF position
before plugging in the
machine.
EQUIPMENT ACCESSORIES.
●
It is important that you refer to the
owner's manual for determining what
are the recommended accessories to
use with this type of equipment. Using
accessories that are not recommended in
the owner's manual may increase the risk
of personal injury and/or to people that
are within close proximity of the
machinery.
CHECKING THE EQUIPMENT FOR
●
DAMAGED PARTS.
It is important to inspect the power
tool before using it to check for
damaged parts. Any part of the
machinery that is damaged should be
checked carefully to determine whether
or not it should be used and whether or
not it can function properly for its
intended use.
PAGE 6 DALTOOL DAD2 OPERATING MANUAL V10/2007R1
DALTOOL
®
SAFETY
It is important to check all the moving
of the machinery for proper alignment
and/or possible binding. All broken
or damaged parts should be properly
repaired or replaced. If these parts are
not repaired or replaced the proper
operation of the machine could be
negatively affected. Damaged bits should
be replaced immediately.
NEVER LEAVE A TOOL RUNNING
●
UNATTENDED – TURN POWER OFF
It is important never to leave a tool
running when not in use. Also never
leave the tool until the drill has come to
a complete stop. It is important to always
turn the power tool OFF when leaving the
work area or when a hole is finished.