Check Before Use - daltile DAD2 Operating Manual

CHECK BEFORE USE:

Unpacking:
●
Unpack the tile drill and check for
missing or damaged parts.
Power Supply:
●
Make sure that the power supply cor-
responds with the information on the
machine.
OPERATING PROCEDURES
Use the machine only in combination
●
with the supplied water tank
connection to the main water supply .
Always use the drill guide.
●
It is impossible to drill without a drill
guide. (see page 9). You can improvise a
drill guide using a piece of wood or
plastic. Make a V-shaped insertion like
illustrated and tape or clamp the guide
onto the tile in the desired position.
Always use the GFCI Switch.
●
PAGE 10 DALTOOL DAD2 OPERATING MANUAL V10/2007R1
OPERATING PROCEDURES
(9) or direct
(8)
(11)
Mount the Drill Bit:
●
Prior to the installation of the diamond
●
bit it is important that both the machine
adapter and the diamond bit are cleaned
and greased.
Mount the bit with the flat side opposing
●
the locking screw.
Secure the bit using the socket head
●
screwdriver (7)
Remove the socket head screwdriver.
●
Removal of the bit is done in reverse
●
order. After use dry and lubricate the bit
before putting it back into the original
packing.
Before changing tools always
unplug the machine
Water Supply:
●
When using the water tank (2): Fill the
●
water tank to the 1.3 gallon level and
pressurize by pumping at least 10 times.
Connect the water tank and the hose to
the drilling unit.