Page 2
Keep this Manual in a safe place for future reference. Enter the Serial Number of your new DALTOOL ® Angular Tile Drill DAD2 in the box below. The Serial Number is located on the machine housing PAGE 2 DALTOOL DAD2 OPERATING MANUAL V10/2007R1...
Installation of the diamond bits .................... 11 Ventilation Openings in the housing of the machine ............. 11 Storage after use ........................11 Defects and Faults ......................... 11 4. DIAMOND TILE BITS Diamond Bits ......................... 12 DALTOOL DAD2 OPERATING MANUAL V10/2007R1 PAGE 3...
It is important that all instructions within this manual be followed. Failure to follow these instructions can lead to irreparable damage. PAGE 4 DALTOOL DAD2 OPERATING MANUAL V10/2007R1...
Page 5
There will be no equip ment. If proper footing is not warranty claim. observed by doing such things as over reaching, serious injury may occur. DALTOOL DAD2 OPERATING MANUAL V10/2007R1 PAGE 5...
Page 6
Any part of the machinery that is damaged should be checked carefully to determine whether or not it should be used and whether or not it can function properly for its intended use. PAGE 6 DALTOOL DAD2 OPERATING MANUAL V10/2007R1...
TURN OFF DRILL BEFORE PLUGGING IN ● It is important to make sure that the switch is in the OFF position before plugging in the machine to prevent accidental starting of the machine. DALTOOL DAD2 OPERATING MANUAL V10/2007R1 PAGE 7...
Do not touch the diamond bit during operation. ● Do not leave the machine turned “ON” when not in use. ● Unplug the machine before changing tools or performing maintenance. ● Always use coolant water. ● PAGE 8 DALTOOL DAD2 OPERATING MANUAL V10/2007R1...
Make a V-shaped insertion like illustrated and tape or clamp the guide onto the tile in the desired position. Always use the GFCI Switch. (11) ● PAGE 10 DALTOOL DAD2 OPERATING MANUAL V10/2007R1...
When water comes out this small hole it is recommended that you stop using the machine and to contact your local service center. Continuing to use the machine can result in damage to your machine DALTOOL DAD2 OPERATING MANUAL V10/2007R1 PAGE 11...