Advertisement
ber of times and go directly to that feature. You can not jump
around. Once you make it to Feature #6, the programming will
end and you have to start over again (you can not go from Feature
#6 to Feature #1 by pressing the valet switch one more time).
• If the vehicle horn is connected, it will beep as many times
as you pressed the valet switch to indicate the feature to
be programmed.
• If the optional LED is connected, it will flash as many times
times matching the feature number you have selected to
program.
4. Once the feature you want to adjust has been selected, rotate
the ignition key to the "On" or "Off" position as indicated on the
programming chart. In some cases, you will have to turn the
Feature Number
Chirp/LED Confirmation
1
2
3
4
5
6
2-Pulse Unlock Off/On Note:
Set Off: For most vehicles that require only single pulse to unlock the doors.
Set On: For some vehicles that require two pulses to unlock the doors.
Operations
A. TRANSMITTER OPERATION
Designated Channel (4 Button Transmitter)
Transmitter Button
Button 1
Lock Door or Unlock Door
Button 1
Panic Function
Button 2
Pop Trunk Release/Channel 2 Output
Button 1 & 2 (Both)
Silent Door Lock/Unlock
Button 3
Channel 3 Output
Button 4
Car Finder
Auto Channel (4 Button Transmitter)
Transmitter Button
Button 1
Lock Door
Button 1
Panic Function
Button 2
Unlock Door
Button 1 & 2 (Both)
Silent Door Lock/Unlock
Button 3
Pop Trunk Release/Channel 2 Output
Button 4
Channel 3 Output
Turn Ignition from "Off" to "On"
1 Short Chirp Feature is "On"
1
Ignition On/Off, Door Lock/unlock
2
Auto Activating Door Locks
3
Doors Locked with Transmitters
After Unlock, Parking Lights Stay On
4
for 30 sec.
5
Door Lock/Unlock 0.9 Sec. Timer
6
2-Pulse Unlock Off
System Function
System Function
ignition key "On" and then "Off" to program the feature.
Note: When programming the features, the LED and parking
lights will not indicate if a feature is on or off. The only indication
is the car horn. A temporary 12 volt siren can be connected to the
brown wire to act as the horn when the horn is not connected to
the M2a.
5. When you are finished setting all the programmable features,
wait for 15 seconds and the M2a will exit the programming
mode automatically.
• If the vehicle horn is connected you will hear 3 short
beeps.
Remark
Press for 3 Seconds
Press for 2 Seconds
Remark
Press for 3 Seconds
Press for 2 Seconds
Turn Ignition from "On" to "Off"
2 Short Chirps Feature is "Off"
No
No
Doors Locked with Built-in Timer
Feature is Off
Door Lock/Unlock 3.6 Sec. Timer
2-Pulse Unlock On
Button 1
Button 3
Button 2
Button 4
Advertisement
