Advertisement
Quick Links
M2a Owner's & Installation Manual
Wiring Diagrams
Positive 3-Wire Door Lock System
Blue Wire
Door Lock
Green Wire
Door Unlock
10-PIN Connection
For technical assistance, please call (800) 638-3600,
or visit www.magnadyne.com
10-Pin White
3-Pin Black
2-Pin White
10-Pin Connector
For Connection Instructions
See Diagram Below
Master
Locking
Switch
To Existing Lock Relay
+ 12V
To Existing Unlock Relay
White Wire: +Parking Light Output
Red Wire: +12V To Fuse Box (Battery)
Brown Wire:
Black Wire: To Chassis Ground
Orange Wire: 500mA Grounded When Armed (Optional Relay Needed)
Gray Wire: (-) Channel 2 Output (Optional Relay Needed)
Green Wire: (-) Channel 3 Output (Optional Relay Needed)
Blue Wire: Do Not Connect. Please Tape Off
Violet Wire: (-) Dome Light Output (Optional Relay Needed)
Yellow Wire: To Ignition Key (Switched +12V)
Note: A sound device (horn or siren) must be connected for proper feature programming indications.
Black Wire: Antenna (Do Not Ground)
2-Pin Blue
Blue Wire: Door Lock (See Diagram Below)
Green Wire: Door Lock (See Diagram Below)
LED (Optional)
Negative 3-Wire Door Lock System
Blue Wire
Door Unlock
Green Wire
Door lock
10A
15A
(-) Output for Horn Relay or 12V Siren
Valet Switch
Master
Locking
Switch
To Existing Unlock Relay
Ground
To Existing Lock Relay
Vehicle Parking
Lights
+12V Siren
Or
Vehicle Horn
Advertisement
Related Manuals for Marksman M2A
Summary of Contents for Marksman M2A
- Page 1 M2a Owner’s & Installation Manual For technical assistance, please call (800) 638-3600, or visit www.magnadyne.com Wiring Diagrams Black Wire: Antenna (Do Not Ground) 10-Pin White 2-Pin Blue 3-Pin Black 2-Pin White 10-Pin Connector Valet Switch For Connection Instructions See Diagram Below...
- Page 2 A maximum of 4 transmitters can be programmed to control the • If the optional LED is connected, it will stop flashing for functions of the M2a. There are 2 modes of transmitter operation. a second or two. • Dedicated Channel Mode (each button performs a •...
- Page 3 5. When you are finished setting all the programmable features, • If the optional LED is connected, it will flash as many times wait for 15 seconds and the M2a will exit the programming times matching the feature number you have selected to mode automatically.
- Page 4 This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference. 2. This device must accept any interference received, including interference that may cause undesired operation. M2A-0MIM © Copyright 2004 Rev. A 2-4-04 Magnadyne Corporation...