Advertisement
Optional Relay Wiring
Parking Light (Dual Relay, European Vehicles Only)
IN4001 Diode
87
87A
86
30
White Wire
IN4001 Diode
87
87A
86
30
Horn Output (Relay is Existing
in Vehicle or Newly Installed)
Brown Wire
86
Channel 3
87
Green Wire
87A
86
85
30
Programming
A. TRANSMITTERS
A maximum of 4 transmitters can be programmed to control the
functions of the M2a. There are 2 modes of transmitter operation.
• Dedicated Channel Mode (each button performs a
dedicated function)
• Auto Configuration Mode (buttons function as per the
icons printed on them)
Note: You can not mix transmitter operation modes
Dedicated Channel Mode:
1. Turn the ignition key to the "On" position.
2A. Push the valet switch 3 times to program in Dedicated
Channel Mode.
2B. Push the valet switch 6 times to program in Auto
Configuration Mode.
• If the vehicle horn is connected, you will hear 1 long + 1
short beep for Dedicated Channel Mode or 2 short + 1
long beep for Auto Configuration Mode.
• If the optional LED is connected, it will begin to flash for
10 seconds.
Note: You will have only 10 seconds to start programming the
transmitters. After 10 seconds has past with no programming
activity, the system will exit the programming mode.
3. Press any button on the first transmitter.
Left
85
+12V DC
Right
85
+12V DC
+
Horn
87
87A
+12V Battery
85
30
+12V or Ground
Depending on
System Requirements
+12V DC
Electric Device
Starter Disable
IN4001
Diode
Orange Wire
87A
86
OFF
ON
Start
ACC
Channel 2 (Trunk Release)
87
Gray Wire
87A
86
85
30
Dome Light
87
Violet Wire
87A
+12V DC
86
85
30
Courtesy Light
• If the vehicle horn is connected you will hear 1 beep.
• If the optional LED is connected, it will stop flashing for
a second or two.
• The parking lights will flash 1 time.
4. Press any button on the second transmitter.
• If the vehicle horn is connected you will hear 2 beeps.
• If the optional LED is connected, it will stop flashing for
a second or two.
• The parking lights will flash 1 time.
5. Apply the same procedure to program a 3rd and 4th transmitter.
PROGRAMMING SYSTEM FEATURES:
The M2a has 6 features that are programmable. To program these
features, repeat the following procedures:
1. Turn the ignition key "On" and then "Off".
2. Within 10 seconds, press the valet switch 6 times.
• If the vehicle horn is connected you will hear 1 long beep
• If the optional LED is connected, it will be on constant
(not flashing).
3. Select the feature you want to program (see feature chart on
next page) by pressing the valet switch.
Note: Feature selection using the valet switch is sequential. Press
the valet switch 1 time to select Feature #1. Press the valet switch
two times to select Feature #2 and so on. If you only have 1 fea-
ture to program, you can press the valet switch the correct num-
40A High Current
87
Relay
85
30
Starter
Cut
Trunk Release
Switch
+12V DC
Trunk Release
Solenoid
+12V or Ground
Depending on
System
Requirements
Advertisement
