Error Indications - Yamaha DISKLAVIER ENSPIRE ST/PRO Owner's Manual

Error Indications

The error indicator may flash in red when some error has occurred. Refer to the table below for an
explanation of the indication.
Example of Indication:
Flashing Lighting up
Indication
Twice
Twice
• Error message also appears on the control screen of the ENSPIRE Controller app. To close the message,
tap on "Close" on the pop-up.
• Pressing any of VOLUME +/– or PLAY/PAUSE buttons turns off the error indicator, and the VOLUME
indicators return to the previous status.
Situation
Firmware update is failed.
Two or more USB flash memories
are connected at the same time.
The USB flash memory is
protected.
The wireless router (access point)
is not found.
The Disklavier cannot obtain the IP
address.
The piano control unit does not
work properly.
Troubleshooting
Remedy
Turn the power off. Download the
update program and try to update
the firmware again. If the problem
still persists, consult your Yamaha
piano dealer.
You can use only one USB flash
memory at a time. Disconnect the
other USB flash memory.
Unprotect the USB flash memory.
Make sure that the wireless router
(access point) is turned on.
If you connect the Disklavier and
the wireless router (access point)
using an Ethernet cable, make
sure that the cable is firmly
connected to the wireless router
(access point).
Check the settings of your network
devices.
Consult your Yamaha piano
dealer. If you are using the
ENSPIRE Controller app, please
tell them the message on the
screen.
Chapter
4
24