Table of Contents
Advertisement
Configuration
5.
6.
Callback Center Setup by Modem Connections
7.
8.
9.
Rev 1.00
Highlight the box beside E-mail recipient and enter the recipient's e-mail
address. Use the virtual keyboard (see
Highlight the box beside E-mail sender and enter the sender's e-mail address.
Note
The e-mail address must include the character @ to be a valid
address.
Figure 3-47
Highlight the box beside Pager Number and enter the telephone number of
the pager. Enter the number as it must be dialed from your telephone system;
for example, if you must dial 9 for an outside line, enter 9 before the pager
number.
Highlight the box beside Mailbox and enter the voice mailbox number if your
pager uses a voice mailbox.
Highlight the box beside Site ID and enter a three-digit site ID number.
When an event occurs, the DVR dials the pager and leaves a four-digit number.
The first three digits are the site ID number and the last digit is the type of event
(1: Alarm In, 2: Motion Detection, 3: Video Loss, 10: Storage is Bad, and 12:
S.M.A.R.T. Alert). For example, 0753 means that Site 75 has lost video.
Note
The DVR waits for at least four minutes between pages. If
another event occurs less than four minutes after the DVR has
notified a pager, it will not dial the pager. It does this so that the
telephone line is not tied up.
Figure
Callback Center (Modem) Setup Screen
66
3-7) to enter the e-mail address.
Document 900.0258
09/04
Advertisement
Table of Contents
