IBM Aptiva 2170 Hardware Maintenance Service Manual page 74

Table 2-1 POST Error Codes and Messages List
NOTE:
To diagnose a problem, first find the BIOS error messages or codes in left
column. If directed to a check procedure, replace the FRU indicated in the check
procedure. If no check procedure is indicated, the first Action/FRU listed in right
column is the most likely cause.
BIOS Error Codes, Messages
0962
Onboard Parallel Port Conflict(s)
0962
Onboard Parallel Port I/O Address
Conflict(s)
0962
Onboard Parallel Port IRQ Conflict(s)
0962
Onboard ECP Parallel Port DMA
Conflict(s)
1162
Onboard Serial Port Conflict(s)
1162
Onboard Serial Port I/O Address
Conflict(s)
1162
Onboard Serial Port IRQ Conflict(s)
1655 Hard Disk Drive(s) Write Protected
1762
Onboard IDE Primary Channel I/O
Address Conflict(s)
1762
Onboard IDE Primary Channel IRQ
Conflict(s)
1762
Onboard IDE Secondary Channel I/O
Address Conflict(s)
1762
Onboard IDE Secondary Channel IRQ
Conflict(s)
40
Action/FRU
Enter BIOS Setup and load the default
settings.
Remove all adapter cards that are NOT
factory-installed, then reboot the system.
Ensure that the diskette drive is not set to
[Write Protected] in the Security Options in
BIOS Setup.
Load default settings in Setup.
Enter BIOS Setup and load the default
settings.
Remove all adapter cards that are NOT
factory-installed, then reboot the system.