Table of Contents
Advertisement
AMPLIFIER
G
F
DIGITAL AUDIO OUT
PCM/MPEG2/AC3/DTS
MAINS
OPT OUT
Cinemalink (on SCART)
This DVD player is equipped with cinemalink feature (from
Philips) which allows a more complete control of your
home audio/video (AV) equipment.
Cinemalink interconnection plug & play will enable the AV
system to recognise the users intention and automatically
switch the necessary controls or input source accordingly.
This will reduce the necessity of having multiple control
inputs for all AV equipments (eg. TV and Amplifier).
Connecting to an amplifier equipped with
Dolby Surround™
Dolby Surround sound
1
Connect the player to the TV, then connect the player's
audio Left and Right out jacks to the corresponding in jacks
on the Dolby Surround™ Audio/Video receiver, using the
audio/video cable supplied (D).
If your amplifier is equipped with a Dolby
Digital™ decoder,
¶ Connect the player as described in 'Connecting to an A/V
receiver with multi-channel decoder'.
If your TV is equipped with a Dolby Surround™
decoder,
¶ Connect the player to the TV as described in 'Connecting
to a TV'.
Remote control battery
installation
Loading the batteries
1
Open the battery compartment cover.
2
Insert batteries as indicated inside the battery
compartment.
3
Close the cover.
TV
E
I
AUX/VCR
IN
STEREO OUT
II
TV OUT
R
L
(CVBS)
(Y/C)
DIG OUT
AUDIO OUT
VIDEO OUT
S-VIDEO OUT
Caution: Do not mix old and new batteries. Never
mix different types of batteries (standard, alkaline,
etc.)
NTSC/PAL Settings
You can switch the NTSC/PAL setting of the DVD player to
match the video signal of your TV. This setting only affects
the television's on-screen display that shows the stop and
setup modes. You may select either NTSC or PAL. To
change the DVD player setting to PAL or NTSC, follow the
steps below.
1
Unplug the DVD player from the mains.
2
Press and hold 9 and T on the front of the DVD player.
While holding 9 and T, plug in the mains.
3
After PAL or NTSC appears on the display panel of the
DVD player, release 9 and T at the same time. The PAL
or NTSC that appears on the display panel indicates the
current setting.
4
To change the setting, press T within three seconds. The
new setting (PAL or NTSC) will appear on the display
panel.
General explanation
About this manual
This manual gives the basic instructions for operating this
DVD player. Some DVDs require specific operation or
allow only limited operation during playback. In these cases,
the player may not respond to all operating commands.
When this occurs, please refer to the instructions contained
with the DVD. When the symbol Ä appears on the TV
screen, the operation is not permitted by the player or the
disc.
Remote control operation
¶ Unless otherwise stated, all operations can be carried out
with the remote control. Always point the remote control
directly at the player, making sure there are no obstructions
in the path of the infrared beam.
When there are corresponding keys on the front panel of
the player, they can also be used.
P
13
REPARATION
Advertisement
Table of Contents
